Load "TEST_C8T6\\TEST_C8T6.axf" Set JLink Project File to "d:\synchronous\School\STM32\CubeMX\F103C8T6\TEST_C8T6\MDK-ARM\JLinkSettings.ini"* JLink Info: Device "STM32F103C8" selected. JLink info: ------------ DLL: V7.00a, compiled Apr 16 2021 15:32:47 Firmware: J-Link ARM-OB STM32 compiled Aug 22 2012 19:52:04 Hardware: V7.00 S/N : 20090930 Feature(s) : RDI,FlashDL,FlashBP,JFlash,GDBFull * JLink Info: InitTarget() start * JLink Info: InitTarget() end * JLink Info: Found SW-DP with ID 0x1BA01477 * JLink Info: DPv0 detected * JLink Info: Scanning AP map to find all available APs * JLink Info: AP[1]: Stopped AP scan as end of AP map has been reached * JLink Info: AP[0]: AHB-AP (IDR: 0x14770011) * JLink Info: Iterating through AP map to find AHB-AP to use * JLink Info: AP[0]: Core found * JLink Info: AP[0]: AHB-AP ROM base: 0xE00FF000 * JLink Info: CPUID register: 0x411FC231. Implementer code: 0x41 (ARM) * JLink Info: Found Cortex-M3 r1p1, Little endian. * JLink Info: FPUnit: 6 code (BP) slots and 2 literal slots * JLink Info: CoreSight components: * JLink Info: ROMTbl[0] @ E00FF000 * JLink Info: ROMTbl[0][0]: E000E000, CID: B105E00D, PID: 001BB000 SCS * JLink Info: ROMTbl[0][1]: E0001000, CID: B105E00D, PID: 001BB002 DWT * JLink Info: ROMTbl[0][2]: E0002000, CID: B105E00D, PID: 000BB003 FPB * JLink Info: ROMTbl[0][3]: E0000000, CID: B105E00D, PID: 001BB001 ITM * JLink Info: ROMTbl[0][4]: E0040000, CID: B105900D, PID: 001BB923 TPIU-Lite ROMTableAddr = 0xE00FF000 * JLink Info: Reset: Halt core after reset via DEMCR.VC_CORERESET. * JLink Info: Reset: Reset device via AIRCR.SYSRESETREQ. Target info: ------------ Device: STM32F103C8 VTarget = 3.300V State of Pins: TCK: 0, TDI: 0, TDO: 1, TMS: 0, TRES: 1, TRST: 0 Hardware-Breakpoints: 6 Software-Breakpoints: 8192 Watchpoints: 4 JTAG speed: 4000 kHz Erase Done.Programming Done.Verify OK.* JLink Info: Reset: Halt core after reset via DEMCR.VC_CORERESET. * JLink Info: Reset: Reset device via AIRCR.SYSRESETREQ. Application running ... Flash Load finished at 22:21:13